GFF Series™ Lighting Fixtures

Benefits
  • Labor savings! Fast installation saves time and reduces labor cost.
  • Reliable, durable, maintenance free performance!
  • Long lasting fixture will not deteriorate under most hostile environments when it is installed according to factory procedures.
  • 99% of all orders are shipped on time!
Features
  • Suitable for indoor or outdoor use.
  • Multiple configurations available for T5 or T8 lamps in 4-Foot and 8-Foot lengths.
  • Ingress Protection - NEMA 6P and IP67 rated dust and moisture resistant luminaire; suitable for use in wet locations where high-pressure wash-down is required.
  • Certified and tested by NSF International to ANSI Standard 2.†
  • Continuous “poured-in-place” closed cell polyurethane gasket completely seals the fixture from dust and moisture.
  • Fixture Mounting Hardware allows the contractor to pre-install the mounting brackets to the mounting surface without drilling into the fixture housing.
  • Tethered gear tray simplifies installation and power-to-ballast connection.
  • Luminaire Disconnect-Enables the electrical contractor to easily and safely disconnect the incoming power and allow safe servicing of the GFF Series Fixtures.
  • Impact resistant acrylic diffuser attaches to the fixture housing without tools.
  • “Captive” Polycarbonate or Stainless Steel Cam Latches.
  • Domestic Ballast Manufacturer.
  • 100% factory tested before shipping. No contractor callbacks!
  • Two (2) 1/2” trade size knockouts accommodate standard conduit fittings.


Ordering Information Example: G4L2T8CLM

Δ Lamps per Fixture

  • 4-Foot GFF Light Fixture: Maximum of three (3) T5 or T8 lamps.
  • 8-Foot GFF Light Fixture: Maximum of six (6) T5 or T8 lamps. Note: The 8-Foot fixture will NOT accommodate F96 lamps.

* Minimum Starting Temperature

  • T5 GFF Light Fixture - High Output Ballast: -20°F / 29C°.
  • T8 GFF Light Fixture - Standard Output Ballast: 0°F / 18C°.
  • T8 GFF Light Fixture - High Ballast Factor (HBF): -20°F / 29C°.

Note: High Output (HO) lamps operate with a higher current, therefore, requiring ballasts to match the high output lamp designation and design. High Ballast Factor is a system operating a standard output lamp to a higher wattage and lumen performance within the standard lamp design.

L - Luminaire Disconnect: Enables the electrical contractor to easily and safely disconnect the incoming power and allow safe servicing of the GFF Series Fixture and/or ballasts without exposure to electrical shock. Complies with the 2008 NEC Article 410.130 (G) and CEC 30-308 (4) requirements for non-residential wiring of luminaires with ballasts.

Options

◊ M - Fixture Mounting Hardware: Maintain the NEMA 6P and IP67 Ingress Protection rating of the GFF Series Lighting Fixture by using the Fixture Mounting Hardware (FMH). The FMH eliminates drilling into the fixture housing and allows the contractor to pre-install the mounting brackets to the mounting surface. The Fixture Mounting Hardware includes two (2) stainless steel mounting brackets and two (2) bail hangers. Use the bail hangers for chain or cable hanging installations.

Note: When specified, the Fixture Mounting Hardware is packaged with your GFF Series Lighting Fixture order.

Recommended Lamp Types and Wattage Size

  • T5 Lamps: For High Output (HO) T5 F54 lamps only.
  • T8 Lamps: For standard output T8 F32 lamps only. T8 High Output (HO) lamps cannot be used with this fixture.

Warning: VHO Lamps must never be used under any circumstances or you will damage the GFF Series Lighting Fixture.